EASYJoint PRO

Firstly, pre-soak the paving.

Remove the bottle of resin activator from the EASYJoint PRO tub. Using a powered paddle, mix the sand for 1 minute, ensuring the sand is free flowing.

Empty the contents of the activator bottle into the sand.

Mix thoroughly for 6 minutes maximum until the mixture has a creamy consistency.

Fill a 1/4 of the activator bottle up with clean water. Replace the lid and shake well. Then empty the contents into the mixed sand.

Mix for a further 3 minutes to create a pourable slurry.

Ensure the paving is still wet. Then, pour the tub contents over a small area of paving.

Spread the slurry over the paving, working diagonally to the joints. Spray lightly with water to maintain a slurry consistency to aid sand movement..

Sweep the paving to remove any leftover compound. Adding a fine mist to assist with the cleaning. DO NOT WASH THE SURFACE!

Top Tip! You can use a leaf blower to disperse fine sand grains.

A slight residue may remain, giving the paving an enhanced appearance. This will fade over time.